Page 1 of 1

Just for Fun! msmac3D recon of PA State Police Crash test

Posted: Wed Nov 01, 2017 10:08 pm
by MSI
Just for Fun Videos:
  • (Why we say Just for Fun is because we did this preliminary reconstruction without yet obtaining the actual vehicle make/model/years and with no measurements of area of impact, tire marks and positions and orientations of rest. We simply guessed makes/models and visually matched the impact and rest positions from adjusting impact location, speeds and offset until we approximately matched the video.)
https://www.youtube.com/watch?v=Fdfw9sRKEo0&list=PLBh3OTTiCozN1HLcEZRXsszyMeSNSgR-N
To Watch more validation comparison videos:

Re: Just for Fun! msmac3D recon of PA State Police Crash test

Posted: Wed Nov 01, 2017 11:56 pm
by MSI
https://youtu.be/Ia1eQRuz_OE
HOW TO: How we quickly setup the Preliminary PA State Police Crash test

After seeing a video of a crash test run today at 2017 PA State Police Crash Conference we set up a project to provide a general reconstruction comparison. This video is a HOW TO step by step to set it up.

Re: Just for Fun! msmac3D recon of PA State Police Crash test

Posted: Wed Nov 29, 2017 10:25 am
by MSI
We've received additional information on the 2017 PA State Police tests and so will start adding additional videos soon. This first video is a HOW TO bring in a DXF file and scale and synch a bitmap (overhead picture or Google earth pic) to the measurements in the DXF file https://youtu.be/WCafy2PqJ8g