2 EDR project DEMO with msmac3D

General Questions, answers and information related to the release of the msmac3D program.
MSI
Site Admin
Posts: 2296
Joined: Thu Jun 18, 2009 12:37 pm

2 EDR project DEMO with msmac3D

Post by MSI »

See our write up on This is a quick walk through of a new Demo/project Template with 2 vehicles with EDR. After some tweaks the final correlation was approximately achieved for the PRE-Impact. We also got an approximate range for the DeltaVs for the vehicles but leave that comparison etc to another Demo.
The SPeed1 & Speed2 are the msmac3D Simulation Speeds
the SEQ are the EDR measured valocities
DEMO 2 EDR graphics.jpg
DEMO 2 EDR graphics.jpg (119.52 KiB) Viewed 14610 times
Below is the original calculated acceleration from the EDR Velocities (Every 1/2 second calculate change in speed and divide by 0.5 seconds)
the AXX1 & AXX2 are the accelerations required to match the measured EDR Velocities (see prior diagram)
DEMO 2 EDR graphics ACCEL.jpg
DEMO 2 EDR graphics ACCEL.jpg (119.46 KiB) Viewed 14608 times